Payment & Shipping Terms:
|Compatible:||800/1800 Series Routers||Brand:||Cisco|
|Name:||Micro Sd Memory Card||Feature:||Durable|
Cisco Original MEM-CF-32MB 32MB Compact Flash Memory Card For 880 1800 Routers
Overview ( MEM-CF-32MB )
Cisco 32MB Compact Flash Memory Card For 800/1800 Routers
Installing and Replacing CompactFlash Memory Cards on Cisco 1900 Series Routers
This document describes installing and replacing CompactFlash (CF) memory cards in Cisco 1941 integrated services routers. You can perform these procedures when the router has been installed in its working location with all power and interface cables connected. This document contains the following sections:
CompactFlash memory cards are sensitive to electrostatic discharge (ESD) damage. ESD damage, which can occur when electronic cards or components are handled improperly, results in intermittent or complete failures.
To prevent ESD damage, follow these guidelines:
To remove a CompactFlash memory card from the chassis, perform the following steps. See Figure 8-2.
Step 1 Remove the CompactFlash cover by placing a flat screwdriver in the slot and pushing sideways against the tension to release the cover door. (See Figure 8-1 and Figure 8-3.)
Inserting Screwdriver in to the CompactFlash Cover
Removing the CompactFlash Cover
Step 2 Press the ejector button next to the CompactFlash memory card. The ejector button moves outward so that it projects from the panel.
Step 3 Press the ejector button again. See Figure 8-3. This ejects the CompactFlash memory card part-way out of its slot.
Step 4 Pull the CompactFlash memory card out of its slot.
Step 5 Push the ejector button in until the button is flush with the bezel.
Figure 8-3 CompactFlash Memory Card Slot in Cisco 1900 Series Routers
To install a CompactFlash memory card, perform the following steps (see Figure 8-3):
Step 1 Make sure that the ejector button is fully seated so that it does not project out from the panel.
Note If the ejector button is projecting out from the panel, push it in until it is flush with the bezel.
Step 2 Insert the CompactFlash memory card into the slot until it is fully seated. The ejector button remains flush with the panel.
Note If the ejector button is projecting from the panel after you insert the CompactFlash memory card, remove the CompactFlash memory card, press the ejector button until it clicks, and reinsert the CompactFlash memory card.
Step 3 Replace the CompactFlash cover by pushing it in place until it snaps in place.